Necessary preliminary tasks
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 BMW 328xi, 2012 BMW 328i, 2011 BMW 328xi, 2011 BMW 328i, and 2010 BMW 328xi. However, it is still accessible from the selected car via links, so may be relevant.
- Remove STORAGE COMPARTMENT
- Remove left/right FRONT SEAT
- Remove GLOVEBOX
- Remove SIDE TRIM PANEL IN FOOTWELL on left/right
- Remove ACCELERATOR PEDAL MODULE
Version with central bass speaker:
- Remove CENTRAL BASS SPEAKER TRIM on left/right
Remove holders (1) towards front.
Pull out air duct (2).
Cut out carpet (1) at cutting edge (2) on left/right.
IMPORTANT:
Risk of damage!
Make the cut as far as possible in the direction of the middle of the car to ensure that the cutting edges are covered by the storage compartment/panels.
Pay attention to cable(s) when cutting.
Make the cut as far as possible in the direction of the middle of the car to ensure that the cutting edges are covered by the storage compartment/panels.
Pay attention to cable(s) when cutting.
IMPORTANT:
Risk of damage!
Pay attention to cable(s) when cutting.
Pay attention to cable(s) when cutting.
Cut out carpet (1) at cutting edge (2).
Guide cable back through carpet (1).
Feed out carpet (1) towards rear/top.
Cutting edges (1) shown on removed carpet (2).
Installation:
Apertures (3) serve as alignment points for fitting the carpet (2).