Version 2

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 BMW 328xi, 2012 BMW 328i, 2011 BMW 328xi, 2011 BMW 328i, and 2010 BMW 328xi. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Observe different screw lengths.
Release oil pump screws (1).
Tightening torque: 11 41 2AZ .

Installation:

Replace aluminum screws.

Fig 1: Identifying Oil Pump Mounting Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Detach sprocket (1) in direction of arrow.

NOTE: The chain tensioner pushes the timing chain (3) of the triangular drive upward.
Do not remove camshaft sprocket.

Remove oil pump (2) in direction of arrow.

Fig 2: Removing Sprocket Wheel

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Check spacer bushings (1) for secure seating and damage; replace if necessary.

Align twin surface (3) on oil pump (2) to sprocket wheel.

Install oil pump (2).

Fig 3: Identifying Spacer Bushings And Oil Pump

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: The special tool bore for the TDC position is located on the inlet side underneath the starter motor.

Rotate engine at central bolt and secure flywheel in position with special tool 11 0 300 .

Fig 4: Rotating Engine Central Bolt

Courtesy of BMW OF NORTH AMERICA, INC.

Secure flywheel with special tool (1) 11 9 260 and special tool (2) 11 9 266.

NOTE: Make sure that the special tool (1) completely engages in the flywheel teeth (see arrow)

Fig 5: Engaging Flywheel Teeth With Special Tool (11 9 260)

Courtesy of BMW OF NORTH AMERICA, INC.