Airbag plug connection on gas generator/airbag module offset by 90°

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 BMW 328xi, 2012 BMW 328i, 2011 BMW 328xi, 2011 BMW 328i, and 2010 BMW 328xi. However, it is still accessible from the selected car via links, so may be relevant.

There are two ways of unlocking this airbag plug connection on the gas generator/airbag module:

Method 1:

Simultaneously pull cover (1) upwards at lugs on left and right (2).

Fig 1: Pulling Air Bag Plug Connection Cover Upwards

G04728072

Courtesy of BMW OF NORTH AMERICA, INC.

Method 2:

Insert a narrow screwdriver into recess (1) in housing (2).

Carefully pinch cover (3) off (4).

Fig 2: Inserting Cover Into Housing Recess

G04728073

Courtesy of BMW OF NORTH AMERICA, INC.

Cover (1) is not positioned higher than housing (2).

The airbag plug connection is unlocked and can now be detached from the gas generator/airbag module.

Fig 3: Identifying Air Bag Plug Connection Cover And Housing

G04728074

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

After attaching airbag plug connection to gas generator/airbag module, press cover (1) downwards until it rests flat on housing.

Check that it catches properly.

Fig 4: Pressing Cover On Housing

G04728075

Courtesy of BMW OF NORTH AMERICA, INC.