Necessary preliminary work

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 BMW 328xi, 2012 BMW 328i, 2011 BMW 328xi, 2011 BMW 328i, and 2010 BMW 328xi. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Make sure airbag wiring harness is exactly routed when installed.

Cut cable straps.

Release airbag wiring harness (2) from cable holders on seat mechanism.

Raise release clip (3) and pull plug (4) out of plug housing (1).

NOTE: If necessary, release yellow plug housing (1) from holder on seat mechanism.

Fig 1: Pulling Plug From Plug Housing

Courtesy of BMW OF NORTH AMERICA, INC.

Unclip cable holder (1) from seat mechanism (2).

Fig 2: Identifying Cable Tie Of Seat Mechanism

Courtesy of BMW OF NORTH AMERICA, INC.

Unscrew nuts (1).

Installation note:

Replace nuts.

Tightening torques 72 12 02AZ .

Fig 3: Identifying Nuts

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: Feed the wiring harness carefully through the seat and backrest mechanism as the edges of the frame can be sharp.

Installation note:

Make sure wiring harness is correctly laid.