64 11 869 Replacing servodrive for blending flap

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 BMW 328xi, 2012 BMW 328i, 2011 BMW 328xi, 2011 BMW 328i, and 2010 BMW 328xi. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove TRIM PANEL FOR PEDAL ASSEMBLY .

Unfasten plug connection (1) and disconnect.

Unfasten screws (2).

Detach servodrive for blending flap (3) in direction of arrow from heater/air conditioner (4).

Installation:

Place servodrive for blending flap (3) over guide pin (5).

Fig 1: Removing Blending Flap Servodrive From Heater/Air Conditioner

Courtesy of BMW OF NORTH AMERICA, INC.

Servomotors must be re-addressed in the event of replacement!

Addressing can only be carried out with the BMW diagnosis system.

Service functions:

Body
Heating and A/C function
Flap motors
Re-address flap motors