64 11 868 Removing and installing/replacing servodrive for defrosting flap (right)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 BMW 328xi, 2012 BMW 328i, 2011 BMW 328xi, 2011 BMW 328i, and 2010 BMW 328xi. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Servomotors must be re-addressed in the event of replacement!
Addressing can only be carried out with the BMW diagnosis system.
Service functions:

Body
Heating and A/C function
Flap motors
Re-address flap motors

Necessary preliminary tasks:

Remove GLOVEBOX WITH HOUSING

NOTE: For purposes of clarity, the following graphics show the heater/air conditioner removed.

Unfasten plug connection (1) and disconnect.

Release screws (2).

Remove servodrive at side.

Installation:

Do not twist teeth of servodrive.

Fig 1: Identifying Plug Connection And Screws

Courtesy of BMW OF NORTH AMERICA, INC.