64 11 866 Removing and installing/replacing servodrive for blending flap (left)
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 BMW 328xi, 2012 BMW 328i, 2011 BMW 328xi, 2011 BMW 328i, and 2010 BMW 328xi. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
Servomotors must be re-addressed in the event of replacement!
Addressing can only be carried out with the BMW diagnosis system.
Addressing can only be carried out with the BMW diagnosis system.
Service functions:
- Body
- Heating and A/C function
- Flap motors
- Re-address flap motors
Necessary preliminary tasks:
- Remove TRIM PANEL FOR PEDAL ASSEMBLY .
NOTE:
For purposes of clarity, the following graphics show the heater/air conditioner removed.
Disconnect plug connection (1).
Release screws (2).
Remove servodrive at side.
Installation:
Do not twist teeth of servodrive.