61 61 010 Checking/adjusting contact angle of windscreen wiper arms on windscreen

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 BMW 328xi, 2012 BMW 328i, 2011 BMW 328xi, 2011 BMW 328i, and 2010 BMW 328xi. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Wiping quality is increased if the approach angle of the windscreen wiper arms is precisely adjusted.

Adjusting DIMENSIONS of wiper arms:

Reference points (A, B) are the mountings of the wiper blades on the wiper arms to the sealing lip (1) of the cowl panel.

Contact angle (C) is the angle between wiper blade center plane (2) and windscreen.

Fig 1: Identifying Wiper Arms Dimensions

Courtesy of BMW OF NORTH AMERICA, INC.

Remove wiper blade (1) from wiper arm (2).

Pin (3) is locator for special tool 61 6 100 .

Fig 2: Identifying Wiper Blade And Wiper Arm

Courtesy of BMW OF NORTH AMERICA, INC.

Slide special tool 61 6 100 onto pin (1).

Place special tool 61 6 100 on windscreen (2) and read off value in degrees on scale.

NOTE: LHD vehicles are covered by the scale range of 0 to -10 and RHD vehicles by the scale range of 0 to +10.

Fig 3: Sliding Special Tool (61 6 100) Onto Pin

Courtesy of BMW OF NORTH AMERICA, INC.

If the specified number in degrees is not correct, the wiper arm (1) must be bent with the special tool 61 6 110 at the point shown.

Fig 4: Identifying Wiper Arm With Special Tools At Point

Courtesy of BMW OF NORTH AMERICA, INC.