Checking fluid level

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 BMW 328xi, 2012 BMW 328i, 2011 BMW 328xi, 2011 BMW 328i, and 2010 BMW 328xi. However, it is still accessible from the selected car via links, so may be relevant.

Check fluid level with engine switched off at expansion tank of power steering/ride-height control system. The fluid temperature should be approx. 20°C here.

Ensure that the cap is fully screwed in prior to the fill level check.

If necessary, add hydraulic fluid up to Max. marking (1).

IMPORTANT: If the fluid level has dropped to the Min. marking (2), you must check the power steering and ride-height control for leaks and issue a separate invoice for this work.

It is not enough merely to top up the fluid.

Fig 1: Identifying Hydraulic Fluid Level Marks

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: To avoid mix-ups when filling with hydraulic fluid, mark the fluid reservoirs or their caps with identification marks.

ATF Automatic transmission fluid

CHF Pentosin CHF11S

Fig 2: Identifying Fluid Reservoir Caps With ATF Automatic Transmission Fluid And Pentosin CHF11S Identification Marks

Courtesy of BMW OF NORTH AMERICA, INC.