LEMON Manuals: Even more car manuals for everyone
Home >> Mini >> 2010 >> Cooper S, 2D Hatchback, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2885 (Rear Axle - Repair - E91) >> 3353 Springs With Suspension >> 33 53 000 Removing and installing/replacing rear left or right coil spring >> Removal

33 53 000 Removing and installing/replacing rear left or right coil spring: Removal

WARNING: This page is about a different car, the 2012 BMW 328i, 2011 BMW 328i, 2010 BMW 328i, and 2009 BMW 328i. However, it is still accessible from the selected car via links, so may be relevant.

Insert lower spring cup 33 5 012 centrally into coil spring and turn to lowest winding.

Guide spindle 33 5 013, 33 5 014 , 33 5 015 from below through the camber link and the lower spring cup 33 5 012.

Fig 1: Inserting Lower Spring Plate 33 5 012 Into Coil Spring
G04726547Courtesy of BMW OF NORTH AMERICA, INC.

Insert top spring cup 33 5 011 sideways into coil spring and turn to the uppermost winding.

IMPORTANT: Make sure spindle (hexagonal) is correctly seated in upper spring cup 33 5 011!

Pull spindle 33 5 013 down.

Fig 2: Inserting Top Spring Plate 33 5 011 Into Coil Spring
G04726548Courtesy of BMW OF NORTH AMERICA, INC.
WARNING: Danger of injury!
Make sure coil spring is correctly positioned in spring cups.
Fig 3: Identifying Coil Spring Position
G04726549Courtesy of BMW OF NORTH AMERICA, INC.
IMPORTANT: Centre special tools 33 5 011, 33 5 012, 33 5 013, 33 5 014 , 33 5 015 to achieve the greatest possible contact surface with the coil spring.

Check installed position of the special tool 33 5 011, 33 5 012 and 33 5 013, 33 5 014 , 33 5 015, and correct as needed.

Fig 4: Identifying Special Tools On Coil Spring
G04726550Courtesy of BMW OF NORTH AMERICA, INC.

Tighten coil spring using special tools 33 5 016 and 33 5 020 , gripping the spindle of the spring tensioner with special tool 33 5 017.

Remove coil spring upwards.

Fig 5: Tightening Coil Spring Using Special Tools 33 5 016 And 33 5 020
G04726551Courtesy of BMW OF NORTH AMERICA, INC.

If necessary, relieve tension on coil spring.

IMPORTANT: Replacement only: 
Bottom end of coil spring (1) must be flush with opening of spring cup 33 5 012 (see dotted-dashed line)!
Fig 6: Identifying Bottom End Of Coil Spring With Opening Of Spring Plate 33 5 012
G04726552Courtesy of BMW OF NORTH AMERICA, INC.