Installing new rubber mount

WARNING: This page is about a different car, the 2012 BMW 328i, 2011 BMW 328i, 2010 BMW 328i, and 2009 BMW 328i. However, it is still accessible from the selected car via links, so may be relevant.

If necessary, release knurled screws 33 4 452 and pull off mounting 33 4 455 with spring steel 33 4 456.

Insert rubber mount in the special tools 33 4 451, 33 4 452, 33 4 454, 33 4 453 with spray points at the top.

Fig 1: Installing Rubber Mount Using Special Tools

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: Clean rubber mount prior to drawing in and moisten with Loctite 638.
Spray-on points of rubber mount must point to rear!

All except for M3:

Align rubber mount by way of slot (1) at an angle to rear axle carrier.

Fig 2: Identifying Rubber Mount Alignment Angle (Except For M3)

Courtesy of BMW OF NORTH AMERICA, INC.

M3:

Align rubber mount by way of slot (1) at an angle to rear axle carrier.

Fig 3: Identifying Rubber Mount Alignment Angle (M3)

Courtesy of BMW OF NORTH AMERICA, INC.

Align rubber mount by way of slot to marking on rear axle carrier.

Using special tools 33 4 471, 33 4 474, 33 4 475, 33 4 466 and 33 4 465 draw rubber mount into the rear axle support.

Remove special tool 33 4 450 .

Apply a thin coating of Loctite 638 to new rubber mount.

Draw in rubber mount as far as it will go.

Fig 4: Installing Rubber Mount Using Special Tools

Courtesy of BMW OF NORTH AMERICA, INC.