Installing new rubber mount

WARNING: This page is about a different car, the 2012 BMW 328i, 2011 BMW 328i, 2010 BMW 328i, and 2009 BMW 328i. However, it is still accessible from the selected car via links, so may be relevant.

Insert rubber mount with spray-on points facing upwards in special tool 33 4 451, 33 4 452, 33 4 454, 33 4 453 and pull together.

Insert rubber mount in special tool 33 4 473.

Fig 1: Installing Rubber Mount Using Special Tools

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: Spray-on points of rubber mount must point to rear!

Align rubber mount by way of slot (1) at an angle to wheel carrier.

Fig 2: Identifying Rubber Mount Alignment Angle

Courtesy of BMW OF NORTH AMERICA, INC.

Pull rubber mount with special tool 33 4 465, 33 4 466, 33 4 475, 33 4 474 and 33 4 473 partially into the wheel carrier.

Remove special tool 33 4 450 and pull in rubber mount as far as it will go.

Fig 3: Pulling Rubber Mount Using Special Tools

Courtesy of BMW OF NORTH AMERICA, INC.