33 21... Pressing output shaft out of drive flange and drawing in (output shaft removed from rear differential): Notes
WARNING: This page is about a different car, the 2012 BMW 328i, 2011 BMW 328i, 2010 BMW 328i, and 2009 BMW 328i. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Risk of injury!
It is not permitted to use the impact screwdriver to press out and draw in the output shaft.
It is not permitted to use the impact screwdriver to press out and draw in the output shaft.
IMPORTANT:
Risk of damage!
To avoid damaging the output shaft and adjoining parts, it is essential during the pressing-out process to repeatedly check and if necessary correct the position of the output shaft.
To avoid damaging the output shaft and adjoining parts, it is essential during the pressing-out process to repeatedly check and if necessary correct the position of the output shaft.
IMPORTANT:
To avoid damaging the dust boot, use special tool 33 2 160
to press out and draw in the output shaft after removing the brake disc.
NOTE:
Rounded inside edge of special tool 33 2 160
must point to drive flange.