Installing inner gaiter

WARNING: This page is about a different car, the 2012 BMW 328i, 2011 BMW 328i, 2010 BMW 328i, and 2009 BMW 328i. However, it is still accessible from the selected car via links, so may be relevant.

Push gaiter with cap onto output shaft (1).

Mount special tool 33 2 100 with corresponding shell inserts on output shaft (1).

Press joint (2) over bearing inner race onto output shaft.

Fig 1: Mounting Special Tool (33 2 100) On Output Shaft

G04726477

Courtesy of BMW OF NORTH AMERICA, INC.

Install new circlip (1).

Fig 2: Identifying Circlip

G04726474

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: Keep sealing faces of cap and joint (on both sides) clean and free from grease.

Fill joint at both ends with high-temperature grease.

Fig 3: Filling High-Temperature Grease On Joints Ends

G04726479

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: Risk of damage!
Do not install gaiter with cap and sealing cover on joint without shims.

Apply a thin coating of sealing compound to sealing faces of sealing cover and cap.

Install sealing cover (1) with two bolts, shims and nuts on joint.

Fig 4: Identifying Sealing Cover

G04726480

Courtesy of BMW OF NORTH AMERICA, INC.

Install cap (1) with two bolts, shims and nuts on joint.

Fit hose clamp (2).

Fig 5: Identifying Cap And Hose Clamp

G04726481

Courtesy of BMW OF NORTH AMERICA, INC.