Necessary preliminary tasks

WARNING: This page is about a different car, the 2012 BMW 328i, 2011 BMW 328i, 2010 BMW 328i, and 2009 BMW 328i. However, it is still accessible from the selected car via links, so may be relevant.

Remove DRIVE FLANGE FROM REAR DIFFERENTIAL
If necessary, press off dust cover

Use special tool 00 5 010 and 32 1 060 /33 1 308 to remove radial shaft seal

Fig 1: Removing Radial Shaft Seal Using Special Tools (00 5 010 And 32 1 060)

Courtesy of BMW OF NORTH AMERICA, INC.

Coat housing plate flange and sealing lips of new shaft seal with approved rear differential oil. See REAR AXLE - OPERATING FLUIDS .

Drive in new shaft seal as far as it will go with following special tool(s) (depending on REAR DIFFERENTIAL /outside diameter).

00 5 500 + 33 3 400 : 168K/L - 78x44x10

00 5 500 + 33 4 240 : 188K/L/LW - 90x44x10

00 5 500 + 33 4 250 : 215K/L/LW, 220K to 230K - 100x50x10

Fig 2: Installing Radial Shaft Seal Using Special Tools

Courtesy of BMW OF NORTH AMERICA, INC.

33 5 030 : 210, 215 with lock - 76x50x10