Installing drive flange

WARNING: This page is about a different car, the 2012 BMW 328i, 2011 BMW 328i, 2010 BMW 328i, and 2009 BMW 328i. However, it is still accessible from the selected car via links, so may be relevant.

Coat sealing lips of radial shaft seal and sealing surface of drive flange with differential oil.

Fit drive flange.

Press on drive flange with special tools 23 1 300 , 33 1 341 and 23 1 303, and if necessary 23 1 302 until collar nut can be screwed on.

Fig 1: Pressing Drive Flange Using Special Tools

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: Do not under any circumstances tighten down collar nut beyond marker points in order to avoid damaging the clamping sleeve.

Tighten down collar nut (1) to point where marker points are aligned.

Fig 2: Identifying Collar Nut With Marking Position

Courtesy of BMW OF NORTH AMERICA, INC.

Drive in new retaining plate with following special tools (depending on REAR DIFFERENTIAL ) as far as it will go.

168L/188L/188LW: Use special tools 00 5 500 and 33 3 480
215L/215LW/215 with lock: Use special tools 00 5 500 and 33 3 490

Fig 3: Installing Retaining Plate Using Special Tools 00 5 500 And 33 3 490

Courtesy of BMW OF NORTH AMERICA, INC.