Necessary preliminary work

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 BMW 328xi, 2012 BMW 328i, 2011 BMW 328xi, 2011 BMW 328i, and 2010 BMW 328xi. However, it is still accessible from the selected car via links, so may be relevant.

Remove transmission.
Remove clutch release bearing.

Release bolts (1) and remove guide tube (2).

Fig 1: Identifying Guide Tube With Bolts

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: The shaft seal and the guide tube are replaced together.

Installation note:

Wrap adhesive tape round keyway splines of drive shaft to avoid damaging the sealing ring while it is being installed.

Lubricate sealing lip of sealing ring.

Replace mounting bolts of guide bush.

Tightening torque 23 11 1AZ.