23 01 010 Replacing sealing cap (GS6-17BG/DG)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 BMW 328xi, 2012 BMW 328i, 2011 BMW 328xi, 2011 BMW 328i, and 2010 BMW 328xi. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary work:

Remove GEARBOX
Remove CLUTCH RELEASE BEARING/LEVER

Drive a hole into the sealing cap (1) with a suitable tool (2).

IMPORTANT: Do not use a drill as drillings may result in transmission malfunction.

Fig 1: Drilling Hole Into Sealing Cap Using Tool

G06904893

Courtesy of BMW OF NORTH AMERICA, INC.

Screw special tool 23 0 490 into sealing cap.

Withdraw sealing cap from transmission housing with aid of impact weight.

Fig 2: Inserting Special Tool (23 0 490) Into Sealing Cap

G06904894

Courtesy of BMW OF NORTH AMERICA, INC.

Apply transmission oil to the sealing lip of the sealing cap (1) and insert.

Fig 3: Identifying Sealing Cap

G06904895

Courtesy of BMW OF NORTH AMERICA, INC.

Drive sealing cap firmly home with special tool 23 0 330 .

Fig 4: Inserting Sealing Cap Using Special Tool (23 0 330)

G06904896

Courtesy of BMW OF NORTH AMERICA, INC.