13 62 Senders for Control Unit
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 BMW 328xi, 2012 BMW 328i, 2011 BMW 328xi, 2011 BMW 328i, and 2010 BMW 328xi. However, it is still accessible from the selected car via links, so may be relevant.
TIGHTENING TORQUE SPECIFICATIONS - SENDERS FOR CONTROL UNIT
| Type | Thread | Tightening specification | Measure | |
|---|---|---|---|---|
| 1AZ Camshaft sensor to cylinder head | N52/N52K/N53 | M6x16 | 8.8 Nm | |
| 2AZ Crankshaft sensor to crankcase | N52/N52K/N53 | M6x16 | 3 Nm | |
| 3AZ Knock sensor to crankcase | N52/N52K/N53 | M8x31 | 10 Nm | |
| 4AZ Differential pressure sensor to intake manifold | N52/N52K/N53 | K50x20 | 6 Nm | |
| 5AZ Water temperature sensor, screwed | N52/N52K/N53 | M12x1.5 | 13.5 Nm | |
| 6AZ Magnet wheel to eccentric shaft | N52/N52K/N53 | M6x20 | 8 Nm | |
| 7AZ VVT sensor to bearing bridge | N52/N52K/N53 | M6x14 | 8 Nm | |
| 8AZ Air mass sensor | N52/N52K/N53 | 3 Nm |