11 31 Camshaft
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 BMW 328xi, 2012 BMW 328i, 2011 BMW 328xi, 2011 BMW 328i, and 2010 BMW 328xi. However, it is still accessible from the selected car via links, so may be relevant.
TIGHTENING TORQUE SPECIFICATIONS - CAMSHAFT
| Type | Thread | Tightening specification | Measure | |
|---|---|---|---|---|
| 1AZ ASA screws Upper and lower bearing banks of exhaust camshaft to cylinder head. |
N52K | M7 x 70 | Insert bolts dry. Tighten screws from inside outwards. Jointing torque and angle of rotation must be observed without fail. Jointing torque Torque angle |
8 Nm 60 ° |
| 2AZ ISA screws Bearing cap of intake camshaft to cylinder head. |
N52K | M6 x 30.5 | 9 Nm | |
| 3AZ ASA screws Timing chain module to cylinder head. |
N52K | M6 x 35 | 9 Nm | |
| 4AZ Bearing pin Timing chain module to crankcase. |
N52K | M8 | 20 Nm | |
| 5AZ Bearing pin Timing chain module to cylinder head. |
N52K | M7 | 14 Nm | |
| 6AZ Chain tensioner Chain tensioner to cylinder head. |
N52K | M22 x 1.5 | Replace sealing ring. | 55 Nm |
| 7AZ Plug Assembly opening to cylinder head. |
N52K | M18 x 1.5 | 25 Nm |