Necessary preliminary tasks

• Draw off and dispose of hydraulic fluid from fluid reservoir
• Remove FRONT UNDERBODY PROTECTION
• Remove radiator

Release banjo bolt and detach pressure line from vane pump.

Installation: 

Replace all sealing rings.

Make sure pressure line is laid without tension and with sufficient spacing to adjoining components.

Tightening torque 32 41 8AZ in 32 41 PUMP AND OIL SUPPLY .

Fig 1: Locating Vane Pump Pressure Line Banjo Bolt

Courtesy of BMW OF NORTH AMERICA, INC.

Expose pressure line up to connection on power steering gear.

Release banjo bolt and disconnect pressure line.

Installation: 

Replace all sealing rings.

Make sure pressure line is laid without tension and with sufficient spacing to adjoining components.

Tightening torque 32 41 9AZ in 32 41 PUMP AND OIL SUPPLY .

Fig 2: Locating Banjo Bolt And Pressure Line

Courtesy of BMW OF NORTH AMERICA, INC.