LEMON Manuals: Even more car manuals for everyone
Home >> Mini >> 2010 >> Cooper S, 2D Hatchback, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2862 (Steering And Wheel Alignment - Repair - E91) >> 3241 Pump And Oil Supply >> 32 41 060 Removing and installing or replacing hydraulic steering vane pump (N51, N52, N53) >> Screwing sequence

Screwing sequence

WARNING: This page is about a different car, the 2012 BMW 328i, 2011 BMW 328i, 2010 BMW 328i, and 2009 BMW 328i. However, it is still accessible from the selected car via links, so may be relevant.
  1. Secure vane pump with screws
  2. Tighten side screws to 2 Nm
  3. Tighten front screws to 2 Nm
  4. Tighten down front screws to jointing torque and angle of rotation

    Tightening torque 32 41 6AZ in 32 41 PUMP AND OIL SUPPLY .

  5. Release screws at side and check bolting points for gap freedom
  6. Tighten down side screws to jointing torque and angle of rotation

Tightening torque 32 41 6AZ in 32 41 PUMP AND OIL SUPPLY .

scientia non olet · About LEMON Manuals