Necessary preliminary tasks

WARNING: This page is about a different car, the 2012 BMW 328i, 2011 BMW 328i, 2010 BMW 328i, and 2009 BMW 328i. However, it is still accessible from the selected car via links, so may be relevant.

Disconnect BATTERY NEGATIVE LEAD

Insert Torx screwdriver (T20) roughly straight from below into opening on reverse side of steering wheel up to stop (approx. 5.5 cm).

Swing Torx screwdriver (T20) with handle sideways until airbag unit is unlocked.

Repeat procedure on other side.

Installation:

Make sure electrical lead is correctly positioned.

Snap airbag unit with uniform pressing force plane-parallel in direction of steering column shaft into steering wheel.

Fig 1: Identifying Position For Inserting Torx Screwdriver (T20)

Courtesy of BMW OF NORTH AMERICA, INC.

WARNING: Danger of injury!
Airbag unit may only be set down with the airbag itself facing upwards .

Tilt airbag unit towards rear.

Disconnect plug connection and remove airbag unit.

Fig 2: Locating Airbag Unit Plug Connection

Courtesy of BMW OF NORTH AMERICA, INC.