Necessary preliminary tasks

WARNING: This page is about a different car, the 2012 BMW 328i, 2011 BMW 328i, 2010 BMW 328i, and 2009 BMW 328i. However, it is still accessible from the selected car via links, so may be relevant.

Move steering column adjuster to "top" and "extended" position
Remove trim panel for pedal assembly.
Secure upper section of steering spindle in footwell (can be pushed into steering column)
N51, N52, N53: Remove INTAKE FILTER HOUSING with air intake hose to intake manifold/system

Release clamping screw (1) on steering spindle upper section (2).

Installation:

Clean thread to remove all remnants of screw securing adhesive.

Replace clamping screw.

Clamping screw must rest in groove of steering column.

No kinking permitted!

Tightening torque 32 31 1AZ .

Fig 1: Identifying Clamping Screw On Steering Spindle Upper Section

Courtesy of BMW OF NORTH AMERICA, INC.

Release clamping screw (1) on steering spindle lower section (2).

Move steering wheel to straight-ahead position and remove ignition key.

Detach steering spindle lower section in direction of arrow from steering gear.

Detach steering spindle upper section from steering column.

Installation:

Clean thread to remove all remnants of screw securing adhesive.

Fig 2: Identifying Clamping Screw On Steering Spindle Lower Section

Courtesy of BMW OF NORTH AMERICA, INC.

Replace clamping screw.

Clamping screw must rest in groove of steering gear.

No kinking permitted!

Steering spindle can only be attached in one position on steering gear and steering column.

Tightening torque 32 31 1AZ .