32 11... Replacing gaiter for electric steering gear (EPS) on left or right: Notes
WARNING: This page is about a different car, the 2012 BMW 328i, 2011 BMW 328i, 2010 BMW 328i, and 2009 BMW 328i. However, it is still accessible from the selected car via links, so may be relevant.
Spindle side:
IMPORTANT:
The steering gear must be replaced If the corrosion on the spindle running surface has advanced to such an extent that the steering is acoustically conspicuous under load!
Adhere to the utmost cleanliness.
Do not regrease the spindle running surface. Sufficient special grease was used during assembly for lifetime filling.
Adhere to the utmost cleanliness.
Do not regrease the spindle running surface. Sufficient special grease was used during assembly for lifetime filling.
Rack side:
IMPORTANT:
The steering gear must be replaced if the polished surface of the rack is damaged (e.g. by corrosion)!
Clean rack and check surface for damage (e.g. by corrosion).
Grease rack (refer to STEERING AND WHEEL ALIGNMENT - OPERATING FLUIDS ).
Clean rack and check surface for damage (e.g. by corrosion).
Grease rack (refer to STEERING AND WHEEL ALIGNMENT - OPERATING FLUIDS ).