27 10 720 Replacing servomotor (ATC 300)

WARNING: This page is about a different car, the 2012 BMW 328xi, 2011 BMW 328xi, 2010 BMW 328xi, and 2009 BMW 328xi. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: After replacement, the "Repair" service function must be carried out with GT1.

Disconnect plugs (1 and 2).

Release screw (3) and turn resistor counterclockwise.

Tightening torque 27 00 14AZ .

Fig 1: Identifying Plugs And Resistor Screw

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1) and remove servomotor from transfer case.

Tightening torque 27 00 13AZ .

Fig 2: Identifying Servomotor Screws

Courtesy of BMW OF NORTH AMERICA, INC.