Necessary preliminary tasks

WARNING: This page does not describe the selected car, but rather 11 other vehicles, including the 2013 BMW 328xi, 2012 BMW 328xi, 2011 BMW 328xi, 2010 BMW 335xi, and 2010 BMW 328xi. However, it is still accessible from the selected car via links, so may be relevant.

Replace PROPELLER SHAFT CENTRE MOUNT

Press grooved ball bearing using special tool 23 1 160 out of center mount (1).

NOTE: Illustration shows E46.

Fig 1: Pressing Grooved Ball Bearing Using Special Tool 23 1 160 Out Of Centre Mount

Courtesy of BMW OF NORTH AMERICA, INC.

Coat rubber-coated bearing seat of center mount (2) with Circolight.

Circolight, refer to BMW Parts Service.

Use special tools 33 3 202/33 3 203 to press deep groove ball bearing (1) into center mount (2).

NOTE: Illustration shows E46.

Fig 2: Pressing Deep Groove Ball Bearing Into Centre Mount Using Special Tools 33 3 202/33 3 203

Courtesy of BMW OF NORTH AMERICA, INC.