Necessary preliminary tasks
WARNING: This page is about a different car, the 2012 BMW 328xi, 2011 BMW 328xi, 2010 BMW 328xi, and 2009 BMW 328xi. However, it is still accessible from the selected car via links, so may be relevant.
- Remove both REAR COIL SPRINGS
- Remove LEFT CONTROL ARM ON WHEEL CARRIER
- Remove both ANTI-ROLL BAR LINKS FROM ANTI-ROLL BAR
- Lower rear axle support See 3331503 LOWERING/RAISING REAR AXLE CARRIER (SPECIAL TOOL SWZ00-2040) or 3331503 LOWERING/RAISING REAR AXLE CARRIER (UNIVERSAL LIFTER)
NOTE:
To simplify the picture, anti-roll bar removal is shown on the removed rear axle.
Release screws (1).
Remove both RUBBER MOUNTS FROM ANTI-ROLL BAR .
Turn anti-roll bar (2) and remove sideways.
Installation:
Check both RUBBER MOUNTS FOR DAMAGE and replace if necessary.
Tightening torque 33 55 1AZ .