33 53 000 Removing and installing/replacing rear left or right coil spring: Installation

WARNING: This page is about a different car, the 2012 BMW 328xi, 2011 BMW 328xi, 2010 BMW 328xi, and 2009 BMW 328xi. However, it is still accessible from the selected car via links, so may be relevant.

Check spring pads (2, 3) for damage.

Remove spring cup (1) and position with upper spring pad (2) on coil spring.

NOTE: Upper spring pad (2) must come into contact with end of coil spring.

Equipment specification with badroad package: Install adapter as well.

Fig 1: Identifying Spring Cup With Spring Pads

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: Observe the following when installing and relieving tension on coil spring:

Lower spring pad must be positively seated in the designated receptacle in the camber arm
NOTE: Otherwise there is a risk of the coil spring jumping out sideways.

Fig 2: Locating Lower Spring Pad Contact With End Of Coil Spring
Courtesy of BMW OF NORTH AMERICA, INC.
Lower spring pad must come into contact with end of coil spring (see arrow)
Lower spring pad must rest flush on last coil (see broken line)

Align coil spring by way of spring cup to opening in side member and relieve tension.

Remove special tools 33 5 011, 33 5 012 and 33 5 013, 33 5 014, 33 5 015.

Fig 3: Identifying Special Tools Position On Coil Spring

Courtesy of BMW OF NORTH AMERICA, INC.