Removing and installing outer gaiter

WARNING: This page is about a different car, the 2012 BMW 328xi, 2011 BMW 328xi, 2010 BMW 328xi, and 2009 BMW 328xi. However, it is still accessible from the selected car via links, so may be relevant.

Release hose clamps (1, 3) and detach gaiter (2) from output shaft.

Clean joint and output shaft carefully.

NOTE: All traces off old grease must be removed.

Fig 1: Identifying Hose Clamps And Gaiter On Output Shaft

Courtesy of BMW OF NORTH AMERICA, INC.

Check joint for damage; if necessary, replace output shaft See 3321001 REMOVING AND INSTALLING/REPLACING LEFT OUTPUT SHAFT or 3321002 REMOVING AND INSTALLING/REPLACING RIGHT OUTPUT SHAFT .

Fill joint with propeller shaft grease.

Fit gaiter (2) on bellows and secure with hose clamps (1, 3).