LEMON Manuals: Even more car manuals for everyone
Home >> Mini >> 2010 >> Cooper S, 2D Hatchback, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2826 (Rear Axle - Repair - E91 (AWD)) >> 3300 General >> 00...... Raising vehicle with trolley jack

00...... Raising vehicle with trolley jack

WARNING: This page is about a different car, the 2012 BMW 328xi, 2011 BMW 328xi, 2010 BMW 328xi, and 2009 BMW 328xi. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT: Observe the following trolley-jack-related instructions:
  1. Use only BMW-distributed/approved trolley jacks which have rubber plate contact points.
  2. Trolley jacks must be regularly serviced and always checked for functional reliability before they are used!
  3. Check the rubber plate on the trolley jack prior to each use, replacing if necessary.
    Fig 1: Identifying Trolley Jack
    G04725307Courtesy of BMW OF NORTH AMERICA, INC.
WARNING: The vehicle may be raised with a trolley jack only  at the following jacking points!
  1. Car jacking point on reinforcement strut (rear-wheel drive)
  2. Side car jacking points
  3. Rear differential

    Risk of damage: It is not permitted to raise the vehicle at the rear differential cover!

  4. Bolting point for rear axle tension struts
    Fig 2: Identifying Car Jacking Points On Reinforcement Strut (Rear-Wheel Drive) And Rear Differential
    G06965108Courtesy of BMW OF NORTH AMERICA, INC.
  1. Car jacking point on front axle carrier (all-wheel drive)
    Fig 3: Identifying Car Jacking Point On Front Axle Carrier (All-Wheel Drive)
    G04725309Courtesy of BMW OF NORTH AMERICA, INC.