Necessary preliminary tasks
WARNING: This page is about a different car, the 2012 BMW 328xi, 2011 BMW 328xi, 2010 BMW 328xi, and 2009 BMW 328xi. However, it is still accessible from the selected car via links, so may be relevant.
- Draw off and dispose of hydraulic fluid from fluid reservoir
- Remove FRONT UNDERBODY PROTECTION
Release banjo bolt and detach pressure line from vane pump.
Installation:
Replace all sealing rings.
Make sure pressure line is laid without tension and with sufficient spacing to adjoining components.
Tightening torque, see 32 41 8AZ in 32 41 PUMP AND OIL SUPPLY
Expose pressure line up to connection on power steering gear.
Release banjo bolt (1) and remove pressure line (2).
Installation:
Replace all sealing rings.
Make sure pressure line is laid without tension and with sufficient spacing to adjoining components.
Tightening torque, see 32 41 9AZ in 32 41 PUMP AND OIL SUPPLY .