84 21 535 Removing and installing/replacing hands-free charging electronics

WARNING: This page is about a different car, the 2011 BMW M3, 2010 BMW M3, 2009 BMW M3, and 2008 BMW M3. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Read and comply with notes on protection against electrostatic damage (ESD PROTECTION) .

NOTE: Comply with notes and instructions on HANDLING OPTICAL FIBRES .

Necessary preliminary tasks

Clamp off BATTERY NEGATIVE LEAD
Remove LUGGAGE COMPARTMENT FLOOR TRIM

E91:

Release retaining clips (1) and remove storage pan (2).

Fold panel (3) upwards.

Fig 1: Identifying Retaining Clips, Panel And Storage Pan

Courtesy of BMW OF NORTH AMERICA, INC.

E88/E84/E93:

Unscrew nuts (1).

Remove holder for telematics control unit/SES (2) in direction of arrow from body.

Raise panel for luggage compartment partition (4) slightly and feed out holder for telematics control unit/SES (2) in direction of luggage compartment.

Release wiring harness fastener (3) from holder for telematics control unit/SES (2).

Fig 2: Removing Holder For Telematics Control Unit/SES From Body

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Make sure guides (5) are correctly seated in associated body holders.

Make sure wiring harness is correctly laid.

Unscrew nuts (1).

Remove charging hands-free electronics and disconnect associated plug connections.

Fig 3: Identifying Charging Hands-Free Electronics Nuts

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

Carry out vehicle programming and encoding
If necessary, log mobile phone on to vehicle