37 14 511 Replacing front ride-height sensor

WARNING: This page is about a different car, the 2011 BMW M3, 2010 BMW M3, 2009 BMW M3, and 2008 BMW M3. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DAMAGE (ESD PROTECTION) .

Release nut (1) and disconnect jointed rod (2).

Installation:

Tightening torque 37 14 3AZ .

Fig 1: Identifying Plug Connection, Jointed Rod With Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (4).

Remove ride-height sensor and disconnect plug connection (3).

Installation:

Sensor lever (5) must point from ride-height sensor to left front wheel.

Tightening torque 37 14 1AZ .

After installation

Check headlight adjustment . See 6310004 ADJUSTING HEADLIGHTS or 6310004 ADJUSTING HEADLIGHTS , correct if necessary