65 82 050 Removing and installing (replacing) on-board monitor

WARNING: This page is about a different car, the 2011 BMW M3, 2010 BMW M3, 2009 BMW M3, and 2008 BMW M3. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DAMAGE (ESD PROTECTION) .

IMPORTANT: Proceed with care so as to avoid damaging the on-board monitor and adjoining trims.

Release screws (1).

Fold out on-board monitor (2) in direction of arrow.

Fig 1: Folding On-Board Monitor

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock plug connections (1) and disconnect.

Installation:

Ensure correct cable routing.

Remove on-board monitor (2).

Fig 2: Identifying On-Board Monitor With Plug Connections

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

Carry out vehicle programming and encoding.