65 83 560 Removing and installing/replacing front trim for Car Communication Computer

WARNING: This page is about a different car, the 2011 BMW M3, 2010 BMW M3, 2009 BMW M3, and 2008 BMW M3. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DAMAGE (ESD PROTECTION) .

Necessary preliminary tasks

Remove CAR COMMUNICATION COMPUTER

Release screws (1).

Fold down front panel for Car Communication Computer (2) and set down.

Installation:

Make sure retaining lugs (3) of front panel for Car Communication Computer (2) are correctly seated.

Fig 1: Removing Car Communication Computer

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: "LIF" stands for Low Insertion Force.

Open catch of LIF plug (2) in direction of arrow and feed out LIF cable (1).

Remove front trim for Car Communication Computer (4) from Car Communication Computer (3).

Fig 2: Opening Catch Of LIF Plug

Courtesy of BMW OF NORTH AMERICA, INC.