65 75 071 Removing and installing (replacing) module for interior movement detector

WARNING: This page is about a different car, the 2011 BMW M3, 2010 BMW M3, 2009 BMW M3, and 2008 BMW M3. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Read and comply with NOTES on protection against electrostatic damage (ESD protection).

Necessary preliminary tasks:

Remove CEILING LIGHT (REAR)

Open retaining shook (1), and detach and remove module for passenger compartment sensor (2) from trim (3) in direction of arrow.

Installation:

Retaining hooks (1) must not be damaged.

Fig 1: Removing Module For Passenger Compartment Sensor From Trim

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

Carry out vehicle programming and encoding .