41 11 028 Stripping Operations - Replacing Left Engine Support (Partial Replacement Before Front Axle)

WARNING: This page is about a different car, the 2011 BMW M3, 2010 BMW M3, 2009 BMW M3, and 2008 BMW M3. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Owing to the different engine variants and equipment specifications, not all the components are taken into consideration.
The following list basically represents the removal sequence.

Clamp off battery lead from negative terminal
Remove bumper trim (FR flat rate number: 5111156)
Remove bumper carrier (FR number: 5111050)
Remove and install intake filter housing (FR number: 1371000)
Remove front panel (FR number: 4133040)
Remove and install left wheel arch cover (front section) (FR number: 5171038)
Remove and install A/C system condenser (FR number: 6453550)
Remove and install hydraulic steering cooling coil (FR number: 1711370)
If necessary, remove and install intercooler (FR number: 1751000)
Partially release left wiring harness