41 34 041 Stripping Operations - Replacing Tail Panel
WARNING: This page is about a different car, the 2011 BMW M3, 2010 BMW M3, 2009 BMW M3, and 2008 BMW M3. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Owing to the different engine variants and equipment specifications, not all the components are taken into consideration.
The following list basically represents the removal sequence.
The following list basically represents the removal sequence.
- Remove and install rear bumper trim (FR number: 5112156)
- Remove and install carrier for bumper trim (FR number: 5112050)
- Remove and install guide for bumper, rear center (FR number: 5112825)
- Remove and install guide for bumper, rear left (FR number: 5112801)
- Remove and install guide for bumper, rear right (FR number: 5112801)
- Remove both rear lights (FR number: 6321180)
- Remove luggage compartment floor trim panel
- Upper tail panel trim (FR number: 5146050)
- Remove and install rear lid striker (FR number: 5124130)
- Remove left luggage compartment wheel arch panel (FR number: 5147151)
- Remove right luggage compartment wheel arch panel (FR number: 5147161)
- Remove and install battery (FR number: 6121010)
- Release wiring harness on tail panel and tie to one side
- Release rear lid seal