52 26... Removing and installing/replacing ski bag with casing on rear seat (through-loading system)

WARNING: This page is about a different car, the 2011 BMW M3, 2010 BMW M3, and 2009 BMW M3. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks

Remove CENTRE ARMREST or
E82 only:
filler element

Press ski bag (1) on rear side out of backrest.

Fig 1: Pressing Ski Bag On Rear Side Of Backrest

Courtesy of BMW OF NORTH AMERICA, INC.

Lift off cover (1).

Unfasten screws (2).

Installation:

Make sure cover is correctly installed.

Fig 2: Identifying Backrest Cover And Mounting Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Unclip single opening trim (1) towards top.

Installation:

Plastic clips must not be damaged.

If necessary, replace faulty trim.

Fig 3: Locating Single Opening Trim

Courtesy of BMW OF NORTH AMERICA, INC.

Remove C-module trim (1) in direction of arrow.

Fig 4: Removing C-Module Trim

Courtesy of BMW OF NORTH AMERICA, INC.