21 52 510 Removing and installing/replacing clutch slave cylinder (plastic)

Seal hydraulic line to clutch slave cylinder with special tool 13 3 010 TERMINAL .

Fig 1: Sealing Hydraulic Line To Clutch Slave Cylinder Using Special Tools (13 3 010)

Courtesy of BMW OF NORTH AMERICA, INC.

Release nuts and remove clutch slave cylinder (1) with holder (2).

Installation: 

Replace self-locking nuts.

Tightening torque 21 52 5AZ .

Fig 2: Identifying Clutch Slave Cylinder Nuts

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock spring retainer (1).

Disconnect hydraulic line (2).

Fig 3: Identifying Hydraulic Line And Spring Retainer

Courtesy of BMW OF NORTH AMERICA, INC.

Press cylinder together by hand.

Connect hydraulic line with cylinder pressed.

Fig 4: Connecting Hydraulic Line With Cylinder

Courtesy of BMW OF NORTH AMERICA, INC.

Remove special tool 13 3 010 TERMINAL .

Hold cylinder piston vertically downwards.

Press piston 5 times into cylinder.

Fig 5: Holding Cylinder Piston

Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

Check pressure hose for traces of abrasion.

If no traces of abrasion by the propeller shaft can be detected on the pressure hose:

The pressure hose must be bent approx. 30 mm away from the propeller shaft.

If traces of abrasion by the propeller shaft can be detected on the pressure hose:

The pressure hose must be replaced.

After replacement, the clutch hydraulics must be BLED  .

Press in piston until it engages.

Install clutch slave cylinder.

Bleed CLUTCH HYDRAULICS  .

Installation: 

Clean thrust member (1) and contact face on release lever.

Lightly grease thrust member (1) on contact face (2).

Fig 6: Pressing Piston

Courtesy of BMW OF NORTH AMERICA, INC.