31 12 080 Removing and installing/replacing both tension struts

WARNING: This page is about a different car, the 2011 BMW M3, 2010 BMW M3, 2009 BMW M3, and 2008 BMW M3. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks

Except M3: Remove BOTH FRONT WHEELS
Remove FRONT UNDERBODY PROTECTION

Release nut (1); if necessary, grip at Torx socket.

Installation:

Keep tension strut to swivel bearing connection clean and free from oil and grease.

Replace self-locking nut.

Tightening torque 31 12 2AZ .

Fig 1: Identifying Tension Strut Nut

Courtesy of BMW OF NORTH AMERICA, INC.

Release bolt (1) and remove tension strut.

Raise locking nut (2) in area of bore and detach from front axle support.

Installation:

Replace locking nut.

Tighten bolt connection in NORMAL POSITION .

Tightening torque 31 12 1AZ .

Fig 2: Identifying Tension Strut Bolt And Front Axle Support Nut

Courtesy of BMW OF NORTH AMERICA, INC.