12 14 700 Coding control module (DME/DDE)

WARNING: This page is about a different car, the 2011 BMW M3, 2010 BMW M3, 2009 BMW M3, and 2008 BMW M3. However, it is still accessible from the selected car via links, so may be relevant.

Switch off ignition

Connect MoDiC or DIS/GT1 Tester.

Switch on ignition.

Select "Coding" program.

For subsequent procedure, follow instructions in MoDiC or DIS/GT1 Tester.

Carry out adjustment of following control units:

EWS (electronic immobilizer)
DME (Digital Motor Electronics)
or
DDE (Digital Diesel Electronics)

Refer to "Diagnosis and Coding" service information bulletins on subject of coding.