64 11 850 Replacing servodrive for rear compartment flap

WARNING: This page is about a different car, the 2011 BMW M3, 2010 BMW M3, 2009 BMW M3, and 2008 BMW M3. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Servomotors must be re-addressed in the event of replacement!
Addressing can only be carried out with the BMW diagnosis system.
Service functions:

Body
Heating and A/C function
Flap motors
Re-address flap motors

Necessary preliminary tasks:

Remove TRIM FOR INSTRUMENT PANEL , bottom right

Unfasten plug connection (1) and disconnect.

Release screws (2).

Detach servodrive for rear compartment flap (3) in direction of arrow from heater/air conditioner (4).

Installation:

Place servodrive for rear compartment flap (3) exactly onto heater/air conditioner (4).

Fig 1: Removing Rear Compartment Flap Servodrive From Heater/Air Conditioner

Courtesy of BMW OF NORTH AMERICA, INC.