72 11 098 Removing and installing/replacing all rear lower belt fittings
WARNING: This page is about a different car, the 2011 BMW M3, 2010 BMW M3, 2009 BMW M3, and 2008 BMW M3. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Read and comply with SAFETY REGULATIONS
for handling airbag modules and pyrotechnical belt tensioners.
Necessary preliminary tasks
- Remove rear seat . See 5226005 REMOVING AND INSTALLING/REPLACING REAR SEAT (THROUGH-LOADING) or 5224005 REMOVING AND INSTALLING OR REPLACING REAR SEAT
Illustration show removal of the left lower belt fitting; proceed in the same way for the right fitting.
Release screw (1).
Tightening torque 72 11 23AZ .
Remove lower belt fitting (2).
Installation:
Pin (3) determines the installation position and prevents the lower belt fitting (2) from turning.
NOTE:
Middle lower belt fitting (4) can only be removed in conjunction with right lower belt fitting.
Lower belt fitting with belt tensioner:
Illustration show removal of the left lower belt fitting; proceed in the same way for the right fitting.
Unfasten PLUG CONNECTION (2) and disconnect.
Release screw (1).
Tightening torque 72 11 23AZ .
Remove lower belt fitting (3).
Installation:
Pin (4) determines the installation position and prevents the lower belt fitting (3) from turning.
NOTE:
Middle lower belt fitting (5) can only be removed in conjunction with right lower belt fitting.