86 21... Removing hinge bracket on rear lid

WARNING: This page is about a different car, the 2011 BMW M3, 2010 BMW M3, 2009 BMW M3, and 2008 BMW M3. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Remove rear lid,
REFER TO 86 21... REMOVING LID.
Remove gas spring, remove gas spring on hinge side only,
REFER TO 86 21... REMOVING GAS SPRING.

Raise edge (1) of retaining clip (2) and slide in direction of arrow towards rear.

Fig 1: Sliding Retaining Clip Edge

Courtesy of BMW OF NORTH AMERICA, INC.

Remove plastic washer (1). Pull hinge bracket (2) in direction of arrow out of mounting bracket (3).

Installation

There must always be a plastic washer (1) fitted on left and right sides of mounting bracket (3).

Fig 2: Pulling Hinge Bracket Out Of Mounting Bracket

Courtesy of BMW OF NORTH AMERICA, INC.