86 21... Removing centering pin from mounting bracket

WARNING: This page is about a different car, the 2011 BMW M3, 2010 BMW M3, 2009 BMW M3, and 2008 BMW M3. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Exclusively for removal of pin, raise the hood in the GFP area. For raising, use a wooden block with a maximum width of 35 mm and a height of 45 mm. The length must be selected depending on the lifting platform securing point. Ensure the hood is secure on the blocks.

Position block (1) so that it is only located in area of sponge rubber seal (2).

Fig 1: Identifying Block And Rubber Seal

Courtesy of BMW OF NORTH AMERICA, INC.

Insert a mandrel into hole (1) of pin (2) and turn counterclockwise.

Fig 2: Identifying Hole Of Pin

Courtesy of BMW OF NORTH AMERICA, INC.