36 11 121 Removing and installing/replacing an RDC trigger transmitter (front)

WARNING: This page is about a different car, the 2011 BMW M3, 2010 BMW M3, 2009 BMW M3, and 2008 BMW M3. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks

Partially detach front WHEEL ARCH TRIM

Press through studs (1) of expander rivets towards rear.

Remove trigger transmitter (2).

Installation:

If necessary, replace expander rivets.

Fig 1: Identifying Studs And Trigger Transmitter

Courtesy of BMW OF NORTH AMERICA, INC.

After installation

Carry out RESETTING OF RDC