34 32 861 Replacing all brake pipes
WARNING: This page is about a different car, the 2011 BMW M3, 2010 BMW M3, 2009 BMW M3, and 2008 BMW M3. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
The brake lines are only supplied in the straight version and correct length with connecting nipple.
Read and comply with GENERAL INFORMATION .
After completing work, BLEED BRAKE SYSTEM .
OBSERVE SAFETY INSTRUCTIONS ON RAISING THE VEHICLE .
Read and comply with GENERAL INFORMATION .
After completing work, BLEED BRAKE SYSTEM .
OBSERVE SAFETY INSTRUCTIONS ON RAISING THE VEHICLE .
The new brake lines are bent into shape with bending tool 34 5 100 DEVICE .
Removed brake pipes can be used as templates for bending.
IMPORTANT:
- Protective coating of brake line must not be damaged during bending.
- Do not kink or bend back brake lines.
- Watch distances to rigid and movable vehicle parts. Brake lines may not make contact or rub.
- Tighten down brake line couplings with torque wrench.
Installation:
Tightening torque 34 32 1AZ .