51 43 075 Removing and installing/replacing side trim panel, footwell, on A-pillar, right

WARNING: This page is about a different car, the 2011 BMW M3, 2010 BMW M3, 2009 BMW M3, and 2008 BMW M3. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks

Remove FRONT ENTRANCE COVER STRIP (INSIDE)
Remove TRIM FOR INSTRUMENT PANEL, BOTTOM LEFT

Detach mucket (1) in area of side trim panel (2).

Unclip side trim panel (2) with special tool in direction of arrow at retaining points (3) and remove.

Fig 1: Removing Side Trim Panel And Mucket

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

If necessary, lever out clips (1) remaining in bores.

If necessary, replace faulty clips (1).

Position side trim panel (2) pre-installed with clips (1) on associated bores and clip into place.

Fig 2: Identifying Side Trim Panel With Clips

Courtesy of BMW OF NORTH AMERICA, INC.